Articles Tagged with ''radiant''

Figure 1 shows a hydronic system that’s intended to supply four panel radiators, each with their own thermostatic radiator valve and an indirect water heater from a gas-fired sectional cast-iron boiler. The system is designed using primary/secondary piping. The primary circulator operates whenever the space heating load or the indirect water heater call for heat. 

The first Blanket of Warmth project was completed in 2018 with two homes. Now, with the grant from the GF Water Foundation via the OneGF Impact Fund, more than a dozen First Nation homes have the Uponor radiant system.

In hydronic systems, the circuit usually passes through the boiler, which adds heat. When using a block heater and the boiler is off, it dissipates heat from the circuit. This heat loss must be considered when measuring the circuit's true "net" heating output.

A case study of a ThermaCEILing radiant system in a Connecticut home.

Single-stage non-modulating heat sources in zoned distribution systems often face short cycling, particularly with low thermal mass. When few zones are active, they struggle to dissipate generated heat quickly, causing temperature build-up and potential shutdown of the heat pump based on internal limits, with varied restart behavior depending on controls.

Last month, we reviewed the basics injection mixing. It’s a method for controlling water temperatures by regulating the flow of heated water “injected” into a circulating distribution system, while simultaneously removing an equal flow of cooler water from that distribution system. Any method that controls the rate of injection flow also controls the rate of heat transfer into the distribution system.

Around 25 years ago, I developed a design that sends high-temperature water to a remote manifold for low-temperature floor heating, mixing it with returning water to achieve the optimal supply temperature, regulated by a variable speed pump. Can you identify a problem with this approach or propose a better one?

At a supply water temperature of 103 ºF, the heating capacity of the heat pump is the same as the total heat dissipation ability of the distribution system. That’s where this system achieves thermal equilibrium. The floor heating zone is fine at this condition, but the output of the air handler is significantly lower than what was planned for based on the assumption that 120 ºF supply water would be available.

The third edition of the Radiant & Hydronics All Stars eBook highlights the latest technologies and design trends in radiant heating. It features insights from our All-Star Roundtable on innovations and challenges, along with design trends for residential and commercial applications.

Zoning has always been a premier benefit of hydronic heating and cooling systems. There are many zoning configurations capable of delivering heat (or cooling effect) when and where it’s needed in a building, with minimal effect on the temperature in other parts of the building. Some methods use circulators to create flow in each zone; others use either motorized or thermostatic valves to regulate flow.