Recalls: Submersible Pump Motor Controllers And Commercial CO2, Temperature Sensors
The
U.S. Consumer Product Safety Commission, in cooperation with Franklin Electric
Co. and GE Infrastructure Sensing Inc., announced a voluntary recall of
electric motor controllers for submersible pump systems (Franklin), and single
beam carbon dioxide and temperature sensors (GE). Consumers should stop using
recalled products immediately unless otherwise instructed.
The model number and date code can be found on the nameplate label located on the right-hand side of the enclosure. About 38,000 units were sold at dealers nationwide from June 2006 through November 2009 for about $245.
Consumers should not touch areas of the units that are exposed due to label curling or peeling and should immediately contact their dealer for a free replacement cover.
For additional information, contact Franklin Electric toll-free at 866/841-6039 between 8 a.m. and 5 p.m. ET daily or visit the firm’s Web site at www.franklin-electric.com.
To see pictures of the recalled product, go to www.cpsc.gov/cpscpub/prerel/prhtml10/10145.html.
The wall-mounted sensors have a Telaire, Carrier or no logo in front of the unit. The model number is not found on the sensor. Determining if a sensor is included in this recall requires inspection of the internal components of the unit.
About 9,400 units were distributed by Carrier, Automated Components Inc., Devices Inc., Direct Digital Controls, Trane, Alps Control Inc., ATS Control Management Inc. and KMC Controls between November 2000 and March 2005 for between $150 and $200. The recalled sensor was distributed for use in commercial buildings.
Building owners should immediately contact GE Infrastructure Sensing for instructions on how to determine if a sensor is included in this recall and if it can be used while awaiting a replacement sensor. Only authorized maintenance personnel should follow these instructions. Building owners with recalled sensors will receive a free replacement sensor.
For additional information, contact GE Infrastructure Sensing toll-free at 877/243-5086 between 8 a.m. and 5:00 p.m. ET or visit the company’s Web site at www.gesensing.com.
To see pictures of the recalled product, go to www.cpsc.gov/cpscpub/prerel/prhtml10/10141.html.
Pumptec Electric Motor Controllers For Submersible Pump Systems
This recall involves the Franklin Electric Co. (Bluffton, Ind.) Pumptec electronic motor controller for 115v/230v submersible motors rated 1/3 to 1 1/2 horsepower with model number 5800020600 and date codes of 06F45 through 09L45. While no incidents or injuries have been reported, the product label can lose adhesion, exposing the circuitry. This could pose a shock hazard to consumers.The model number and date code can be found on the nameplate label located on the right-hand side of the enclosure. About 38,000 units were sold at dealers nationwide from June 2006 through November 2009 for about $245.
Consumers should not touch areas of the units that are exposed due to label curling or peeling and should immediately contact their dealer for a free replacement cover.
For additional information, contact Franklin Electric toll-free at 866/841-6039 between 8 a.m. and 5 p.m. ET daily or visit the firm’s Web site at www.franklin-electric.com.
To see pictures of the recalled product, go to www.cpsc.gov/cpscpub/prerel/prhtml10/10145.html.
GE Telaire Airestat, Carrier Single Beam Carbon Dioxide And Temperature Sensors
This recall involves GE Telaire Airestat CO2 and temperature sensors (with model numbers T8010, T8010-C, T8011, T8011-C, T5010, T5010-C, T5011 and T5011-C) and Carrier Single Beam CO2 and temperature sensors (with model numbers 33ZCT55CO2 and 33ZCT56CO2). The carbon dioxide and temperature sensors can overheat, posing a fire hazard; GE Infrastructure Sensing Inc. (Billerica, Mass.) has received three reports in which a cracked capacitor caused the product to overheat and smoke. No injuries have been reported.The wall-mounted sensors have a Telaire, Carrier or no logo in front of the unit. The model number is not found on the sensor. Determining if a sensor is included in this recall requires inspection of the internal components of the unit.
About 9,400 units were distributed by Carrier, Automated Components Inc., Devices Inc., Direct Digital Controls, Trane, Alps Control Inc., ATS Control Management Inc. and KMC Controls between November 2000 and March 2005 for between $150 and $200. The recalled sensor was distributed for use in commercial buildings.
Building owners should immediately contact GE Infrastructure Sensing for instructions on how to determine if a sensor is included in this recall and if it can be used while awaiting a replacement sensor. Only authorized maintenance personnel should follow these instructions. Building owners with recalled sensors will receive a free replacement sensor.
For additional information, contact GE Infrastructure Sensing toll-free at 877/243-5086 between 8 a.m. and 5:00 p.m. ET or visit the company’s Web site at www.gesensing.com.
To see pictures of the recalled product, go to www.cpsc.gov/cpscpub/prerel/prhtml10/10141.html.
Looking for a reprint of this article?
From high-res PDFs to custom plaques, order your copy today!
